MG MH 2010 B

•  
  Número de referencia 1073-55730

  Fabricación 2008

  Horas en funcionamiento Sin resultados

• Proveedor

  Frech GmbH
  Werderstrasse 82
  74889 Sinsheim

  Germany

  

• Categoría principal

  Máquinas para trabajar el metal

• Categoría

  Máquinas para trabajar la chapa

• Tipo de máquina

  Curvadoras hidráulicas

• Fabricante

  MG

• Control

  ELAP LYNX

• Datos técnicos

  sheet width

  2050 mm

  plate thickness

  10,00 mm ST

  pre-bending

  8,00 mm ST

  diameter of upper rolls

  ~ 220 mm

  side roll diameter

  ~ 170 mm

  diameter of lower rolls

  ~ 190 mm

  bending speed

  ca. 2.0 + 5.0 m/min

  Control

  ELAP LYNX

  oil volume

  80.0 Liter

  voltage

  380 V

  total power requirement

  5.5 kW

  weight

  5000 kg

  range L-W-H

  3500 x 1550 x 1400 mm

• Descripción

  ** Very good condition (!!)
  ** Current new price including accessories approx. 90.000 Euro
  
  Equipment:
  - Robust electro-hydraulic 4-roll bending machine
  - 4-roll concept offers a wide range of bending and rounding options
  - MG NC control unit "ELAP LYNX"
  * Operation - Control of all rolls and machine axes
  * Digital position display
  * Manual operation via joysticks
  * Freely movable control panel
  - Two central rolls are directly driven by hydraulic motors
  - Conical rolling is possible by tilting the rolls
  - Parallelism of the side rolls via torsion shafts
  - Pre-bending on both sides
  - Diameters of up to 1.1 times the top roll diameter are possible
  - Forged and hardened rolls with a hardness of 53-55 HRC
  - Low-maintenance, stable machine design
  - Permanent lubrication of all components Bearings
  - Sturdy welded steel construction
  - 2x bending speeds selectable
  - Electro-hydraulic folding bearing for easy pipe removal
  - Pressure gauge/pressure indicator for the rollers
  - Safety device (safety lanyard with switch unit)
  - Operating instructions (PDF)
  
  
  This ad was created with MODUL MWS - the software solution of LogoTech.

• Estado

  Usado