EHT TSS 4-30

•  
  Número de referencia 1073-94271

  Fabricación 1998

  Horas en funcionamiento Sin resultados

• Proveedor

  Frech GmbH
  Werderstrasse 82
  74889 Sinsheim

  Germany

  

• Categoría principal

  Máquinas para trabajar el metal

• Categoría

  Tijeras

• Tipo de máquina

  Cizallas de guillotina

• Fabricante

  EHT

• Control

  ELGO

• Datos técnicos

  sheet width

  3050 mm

  plate thickness

  4,00 mm ST

  thickness at "Niro-steel"

  2,50 mm

  cutting angle adjustment

  1,00 °

  down holder

  21 Stück

  oil volume

  160 Liter

  strokes per minute

  18 - 31

  Control

  ELGO

  0

  max. 300 bar

  voltage

  400 V

  main drive

  9.0 kW

  weight of the machine ca.

  4800 kg.

  dimensions of the machine ca.

  3660 x 2070 x 2140 mm

• Descripción

  ** From a maintenance workshop
  ** Good condition (!!)
  
  Equipment:
  - Electro-hydraulic swing cut sheet metal shear
  - Machine frame = all-steel welded construction
  - ELGO NC control, control panel at the front left
  * For positioning the electro-motorized backgauge
  * Target/actual position value input possible
  * Adjustment by three-phase motor via toothed belt
  - Support table with ball transfer rollers
  * Grip recesses are located between the table plates
  - Front finger guard
  - Hydraulically operated sheet metal hold-down clamps
  - 1x freely movable foot switch
  - Emergency stop button at the front
  - 1x movable scrap diverter (at the rear)
  - Operating instructions + circuit diagram
  
  ** Special accessories included:
  - EHT pneumatic sheet metal holding device for thin sheet metal blanks
  - 1x EHT extra-long side stop with mm scale & support foot
  - 1x EHT front - movable support arm
  
  
  This ad was created with MODUL MWS - the software solution of LogoTech.

• Estado

  Usado